Fritz! 450E Installation Instructions Manual page 40

No Connection with the Wireless Access Point
Switch the operating mode to "WLAN bridge" in the "System /
Operating Mode" menu in the user interface.
Cause
WPS is disabled on the wireless access point.
Help
Install the latest firmware for your wireless access point and
then enable the WPS function in the access point.
Cause
The encryption of your wireless access point is set to "WEP"
or "non-encrypted". WPS can only be used with WPA/WPA2
encryption.
Help
Configure encryption with WPA/WPA2 in the user interface of
your wireless access point.
Cause
The radio network name (SSID) at your wireless access point
is set to "not visible".
Help
Set the SSID to "visible".
The SSID must be visible to establish a connection using
WPS. Once the connection has been established you can re-
set the SSID of the wireless access point back to "not visi-
ble".
Cause
The MAC address filter of the wireless access point is enabled
and the FRITZ!WLAN Repeater is not entered as an exception
in the MAC address list of the wireless access point.
Help
FRITZ!WLAN Repeater 450E 40