Installing The Gigabit Ethernet Board Kit - Fuji Xerox DocuPrint C5005 d User Manual

A.9

Installing the Gigabit Ethernet Board Kit

This section describes how to install the Gigabit Ethernet Board Kit on the printer.
Important
• Parallel Port Kit and Gigabit Ethernet Board Kit cannot be installed concurrently. If the Parallel Port Kit is
installed, remove the card by reference to " Removing the Parallel Port Kit" (P. 420).
• The interface connecter for standard network cannot be used when the Gigabit Ethernet Board Kit is
installed to the printer.
Installing the Gigabit Ethernet Board Kit
1. Press the <
switch to turn off the power.
Note
• Make sure that there is no indication on the display,
and <Energy Saver> button is off.
2. Open the front cover.
3. Press the <
power switch to turn off the main power and
close the front cover.
Note
• The <Main Power> lamp goes out on the control
panel.
4. Unplug the power cord from the power
outlet and the printer.
422
A Appendix
Gigabit Ethernet Board Kit
> side of the printer's power
> side of the printer's main