Fuji Xerox DocuPrint C5005 d User Manual page 435

• When the [LPD Spool] setting is [Hard Disk]
All of the print data spooled in the printer's hard disk, including data that is currently being
printed, is saved on the printer's hard disk. Printing will be performed from the saved print
data when the power is switched back to on again, even if a new print job has been is
requested.
• When the [LPD Spool] setting is [No Spooling]
All of the print data spooled in the printer's receiving receive buffer, including data that is
currently being printed, is deleted. The print data does not exist is not available when the
power is switched back to on. However, print data may be saved on your computer if the
power is switched off immediately after requesting a print job. In this case, printing will be
performed from the saved print data when the power is switched back on again, even if
a new print job has been is requested.
Printing
• When the [LPD Spool] setting is [Hard Disk] or [Memory]
If the size of the print data is greater than the remaining capacity of hard disk or memory
capacity at the time that receiving the print data receive starts, that print data cannot be
received.
Note
• Some computers may resend the print data immediately automatically if the size of the print data
exceeds the receive capacity. If this happens, it may appear as if the computer has hung up. To avoid
this, cancel sending print data on the computer.
• When the [LPD Spool] setting is [No Spooling]
While a print request is being received from one computer, a print request from another
computer cannot be received.
• When the computer's IP address or and computer name has been changed
The query contact processing or canceling requests from the computer and the delete
process may not operate correctly after the computer's IP address and/or the computer
name has been changed. While there is no print data in the printer's receive buffer, turn
the power off and then back on again.
Note
• A control panel operation can be used to cancel or force-eject printing of the print data in the printer's
receive buffer. For information about the procedure you should use, refer to "2.5 Canceling/Checking a
Print Job" (P. 63).
A.11 Notes and Restrictions
435