Table of Contents
Advertisement
The following shows the reference section for each service.
"E-mail" (P.239)
"Network Scanning" (P.257)
"Scan to PC" (P.259)
"Advanced Settings" (P.280)
"Store & Send Link" (P.274)
Step 3 Starting the Scan Job
The following describes how to start a scan job.
For information on how to start a scan job on the [Store to WSD] screen, refer to "Store to WSD"
(P.277).
1
Press the <Start> button.
Important • If the document has been loaded in the
Note
• If a problem occurs, an error message
• You can set the next job during scanning.
If you have more documents
If you have more documents to scan, select [Next Original] on the touch screen while
the current document is being scanned. This allows you to scan the documents as a
single set of data.
Up to 999 pages can be stored.
Note
• If the number of pages scanned by the machine exceeds the maximum, the machine stops
For information on how to set the maximum number of pages stored for a scan document, refer to "5
Tools" > "Scan Service Settings" > "Other Settings" > "Maximum Stored Pages" in the Administrator
Guide.
2
While documents are being scanned, select
[Next Original].
Note
• When using the document feeder, load
• When [Next Original] is displayed on the
• You can change the scan settings of the next document by selecting [Change Settings] that
document feeder, do not hold down the
document while it is being conveyed.
appears on the touch screen. Solve the
problem according to the message.
scanning. Follow the message displayed on the screen, and either abort the operation or
save the already-scanned data as a single set of data.
the next document after the machine has
finished scanning the first document.
screen shown on the right and no
operation is performed for a certain period
of time, the machine automatically
assumes that there are no more documents.
is displayed after selecting [Next Original].
Scanning Procedure
1
2
3
4
5
6
7
8
9
0
#
C
<Start> button
233
5
Advertisement
Table of Contents
