Permobil K300 Service Manual page 33

PS seat
Removal from chassis with seat angle
1. Switch on the main power switch on the
control panel. Raise the seat angle. Switch off
the main power switch on the control panel.
If the seat angle will not run due to discharged
batteries or defective adjustment device,
remove the front mounting screw of the
adjustment device (see illustration). Then
carefully angle the seat manually.
2. Remove the control panel. See page 36. Cut
off the cable ties holding the cabling in place
on the seat, noting the position of the cable
ties for subsequent fitting.
3. Remove the crush protection devices on the
left and right sides, which are fixed in place
with two screws each (see illustration).
4. Remove the seat, which is held in place with
two screws on the left and right sides (see
illustration). Make a note of which holes the
screws are fixed in for subsequent fitting.
m
nB
The seat is heavy. Two people should therefore lift it. Be
careful with the cabling.
assembly
Assemble in the reverse order.
Front mounting screw of the adjustment device
The crush protection devices on the left and right
sides are held in place with two screws.
The seat is held in place with two screws on the
left and right sides.
33
Seat