Slewing Brackets - Permobil K300 Service Manual

Slewing brackets

Removal
1. Raise the seat; seat elevator to the highest
position; fixed seat tube to the service position.
See page 24. If the seat elevator does not work
normally because the batteries are discharged
or the actuator is defective, the seat can be
raised/lowered manually. See page 22.
2. Switch off the main power switch on the
control panel.
3. Remove the chassis cover.
4. Lift up and chock up the wheelchair chassis
so that the wheel in question is free of the
ground.
5. Remove the front wheel, see page 12.
6. Remove the lower shock absorber bracket.
See page 16.
7. Remove the link arm, it is fitted with screw and
washer.
For removal of wheel forks and wheels, see the
respective chapters.
Fitting
Fit the link arm in the reverse order.
Tighten the screw holding the link arm in place
with a torque wrench.
Tightening torque: 15 nm.
m
Do not use a Pneumatic impact wrench.
Removal/fitting of slewing brackets.
19
Slewing brackets
Slewing bracket attachment.
nOTE