Permobil K300 Service Manual page 34

Seat
CS-seat
Removal
1. Raise the seat; seat elevator to the highest
position; fixed seat tube to the service position.
See page 24. If the seat elevator does not work
normally because the batteries are discharged
or the actuator is defective, the seat can be
raised/lowered manually. See page 22.
2. Switch off the main power switch on the control
panel.
3. If needed, remove the control panel, see page
36-37.
4. Remove the four screws from under beneath,
see figure.
5. Remove the seat.
m
nOTE
Because the seat is heavy, it should be lifted by two persons. Be
careful with the cabling.
6. If needed, remove the leg rest unit, it is fitted
with four screws with washers and nuts, see
fig.
Fitting
Fit the seat in the reverse order.
m
nOTE
Always use the center holes on the leg rest unit when fitting it on
the Seat elevator/Fixed seat post.
m
nOTE
Always use the front holes on the seat when fitting it on the leg
rest unit.
The seat is fitted with four screws.
The Legrest unit is fitted with four
screws with washers and nuts.
Use the center holes on the leg rest unit when
fitting it on the seat lift/fixed seat post.
Use the front holes on the seat when
fitting it on the leg rest unit.
34