PS Junior
Removal on a chassis without seat angle.
1. Raise the seat to the highest position manually.
See page 24 or 26.
2. Switch off the main power switch on the
control panel.
3. Remove the control panel. See pages 36-37.
Cut off the cable ties that hold the cabling to
the seat.
4. On a seat with electric seat angle, detach the
cabling from the connector. This is located at
the rear of the underside of the seat. See the
figure below.
5. Unscrew and remove the four screws
underneath the seat that hold the seat in
place. See the figure.
6. Lift off the seat.
m
nOTE
Because the seat is heavy, it should be lifted by two persons. Be
careful with the cabling.
Fitting
Fit the seat in the reverse order.
The seat can be fitted on the seat lift in two different positions.
In the figure, the seat is viewed from below.
35
The seat is held in place with four screws.
The seat's connector is fitted at the rear of the
underside of the seat.
a B
a B
a B
a B
Seat