Output Stage Rnet - Permobil K300 Service Manual

Output stage
R-net Controler
Removal
1. Switch off the main power switch on the control panel.
2. Remove the chassis covers. See page 8.
3. Disconnect the electrical connections from the output stage. Note their positions (see illustration
below).
PM80
Motor 1
Left
PM90
Motor 1
Left
4. Remove the output stage by unscrewing its
two mounting screws. See fig.
Fitting
Assemble in reverse order. Older models of C300
have output stages of type PM80, while later
models have output stages of type PM90. When
renewing output stages on older models, PM80
may be replaced by PM90.
Note the location of the cable connections, see
photo above.
Battery
Output stage cable connections (Rnet PM80).
Battery
Output stage cable connections (Rnet PM90).
38
Inhibit
External
charging socket
Motor 2
Right
Motor 2
Right
The output stage is fitted with two screws.
BUS
Inhibit
External
charging socket
Actuators