Auto Reset; Table 6-28: Automatic Software Upgrade Cli Parameters - AudioCodes MediaPack MP-402 User Manual

6.8.3

Auto Reset

If autoreset is enabled and any of the files have been upgraded a reset will be initiated
automatically after the automatic upgrade process has been terminated.

Table 6-28: Automatic Software Upgrade CLI Parameters

Parameter
[[no] image-file-url <URL>]
[[no] cpt-file-url <ULR>]
[[no] config-file-url <URL>]
[[no] autoreset]
[[no] update-time [boot |
frequency <hh:mm> | daytime
<hh:mm>]
Using CLI
To configure the automatic software upgrade using CLI:
4.
Log on to the system.
6. Change to the configuration mode.
7. Use the commands in [] to configure the system.
SIP User's Manual
Description
Specifies the name of the SW image file and the location of the HTTP server
(IP or FQDN) from which the gateway loads the new Software.
For example: h ttp://10.0.0.1/mp40x/current_version.
3 0 0 H
Note 1: The filename may contain the string <MAC>. This string will be
replaces with the MAC address of the WAN interface (leading zeros and : as
separator)
Note 2: The maximum length of the URL is 99 characters.
Specifies the name of the cpt file and the location of the HTTP server (IP or
FQDN) from which the gateway loads the new Software.
For example: h ttp://10.0.0.1/mp40x/current_cpt.
3 0 1 H
Note 1: The filename may contain the string <MAC>. This string will be
replaces with the MAC address of the WAN interface (leading zeros and : as
separator)
Note 2: The maximum length of the URL is 99 characters.
Specifies the name of the configuration file and the location of the HTTP server
(IP or FQDN) from which the gateway loads the new Software.
For example: h ttp://10.0.0.1/mp40x/current_cpt.
3 0 2 H
Note 1: The filename may contain the string <MAC>. This string will be
replaces with the MAC address of the WAN interface (leading zeros and : as
separator)
Note 2: The maximum length of the URL is 99 characters.
Defines if the system automatically resets after update of:
•
Image
•
Cpt file
•
Config file
Default: enabled
Defines the update frequency. The following commands are possible
•
no update time: disable automatic update
•
update time frequency hh:mm: Update the system every hh:mm
•
update time daytime hh:mm: update the system daily at hh:mm (24
hour notation)
Default: no update-time
130
MP-40x SIP MediaPack BRI Series
Document #: LTRT-53301