Mounting The Mediapack On A Wall; Figure 3-2: Mediapack With Brackets For Rack Installation - AudioCodes MediaPack MP-402 User Manual

SIP User's Manual
To install the MediaPack in a 19-inch rack take the next 9 steps:
1. Remove the two screws on one side of the device nearest the front panel.
2. Insert the peg on the short bracket into the third air vent down on the column of air
vents nearest the front panel.
3. Swivel the bracket until the holes in the bracket line up with the two empty screw holes
on the device.
4. Use the screws found in the devices' package to attach the short bracket to the side of
the device.
5. Remove the two screws on the other side of the device nearest the front panel.
6. Position the long bracket so that the holes in the bracket line up with the two empty
screw holes on the device.
7. Use the screws found in the device's package to attach the long bracket to the side of
the device.
8. Position the device in the rack and line up the bracket holes with the rack frame holes.
9. Use four standard rack screws to attach the device to the rack. These screws are not
provided with the device.

Figure 3-2: MediaPack with Brackets for Rack Installation

3.3.3

Mounting the MediaPack on a Wall

The MediaPack is mounted on a wall by the addition of two short (equal-length) supplied
brackets. The MediaPack with brackets for wall mount is shown in
To mount the MediaPack on a wall take the next 7 steps:
1. Remove the screw on the side of the device that is nearest the bottom and the front
panel.
2. Insert the peg on the bracket into the third air vent down on the column of air vents
nearest the front panel.
3. Swivel the bracket so that the side of the bracket is aligned with the base of the device
and the hole in the bracket line up with the empty screw hole.
Version 2.4 23
3. Installing the MediaPack
F igure 3-3.
6 1 6 H 6 3 6 H
June 2008