Table of Contents
Advertisement
To connect the MediaPack to the WAN take the next 2 steps:
1.
Connect the RJ-45 connector, at the one end of the Ethernet Cat 5 cable (supplied) to
the MediaPack's WAN port (labeled WAN).
2.
Connect the other end of the cable to the WAN network.
3.4.3
Connecting the ISDN BRI S/T Interface
The MediaPack provides up to four BRI S/T interface ports (depending on MediaPack
model -- refer to
ISDN telephones. Up to eight terminal equipment (TE) devices can be connected per BRI
S/T port by using an ISDN S-bus that provides eight ISDN ports.
The ISDN cabling requirements are as follows:
Connector: 8-pin RJ-45.
Connector Pinouts: refer to
Pin
3
4
5
6
Note: Pins 1, 2, 7, and 8 are NOT connected.
SIP User's Manual
Figure 3-6: MediaPack LAN and WAN Cabling
T able 1-1
on page
1
6 3 3 H 6 5 3 H
6 3 4 H 6 5 4 H
T able 3-1
6 3 5 H 6 5 5 H
Table 3-1: RJ-45 Pinouts for ISDN S/T Interface
Color
White / Green
Blue
White / Blue
Green
MP-40x SIP MediaPack BRI Series
3) for connecting ISDN terminal equipment such as
and
F igure 3-7
below.
6 3 6 H 6 5 6 H
Description
User Side
Tx+
Rx+
Rx-
Tx-
26
Network Side
Rx+
Tx+
Tx-
Rx+
Document #: LTRT-53301
- Quick Links:
- Introduction
Hide quick links:
Advertisement
Table of Contents
