Table of Contents
Advertisement
SIP User's Manual
3
Installing the MediaPack
This section provides information on the installation procedure for the MediaPack.
The equipment must only be installed or serviced by qualified service personnel.
To install the MediaPack:
Unpack the MediaPack (refer to '
Check the package contents (refer to '
Mount the MediaPack (refer to '
Cable the MediaPack (refer to '
After connecting the MediaPack to the power source, the Ready LED on the front panel
turns to green (after a self-testing period of about one minute). Any malfunction changes
the Ready LED to red.
When you have completed the above relevant sections you are then ready to start
configuring the gateway (Chapter
Unpacking
3.1
To unpack the MediaPack take the next 6 steps:
1.
Open the carton and remove packing materials.
2.
Remove the MediaPack gateway from the carton.
3.
Check that there is no equipment damage.
4.
Check, retain and process any documents.
5.
Notify AudioCodes or your local supplier of any damage or discrepancies.
6.
Retain any diskettes or CDs.
Package Contents
3.2
Ensure that in addition to the MediaPack, the package contains:
External power supply with AC power cable
Three brackets (two short, one long) and bracket-to-device screws for 19-inch rack
installation
CD with software and documentation
Printed copy of MediaPack Fast Track Installation Guide
Version 2.4
Caution Electrical Shock
U npacking'
below).
6 0 7 H 6 2 7 H
P ackage Contents'
6 0 8 H 6 2 8 H
M ounting the MediaPack'
6 0 9 H 6 2 9 H
C abling the MediaPack'
6 1 1 H 6 3 1 H
5
on page
5
2).
6 1 3 H 6 3 3 H
6 1 4 H 6 3 4 H
21
3. Installing the MediaPack
below).
on page
2
2).
6 1 0 H 6 3 0 H
on page
2
4).
6 1 2 H 6 3 2 H
June 2008
- Quick Links:
- Introduction
Hide quick links:
Advertisement
Table of Contents
