Adjustments; Parking Brake Latch Switch - Toro Greensmaster eFlex 1800 Service Manual

Adjustments

Parking Brake Latch Switch

The parking brake latch switch is a normally open prox-
imity switch. The switch is attached to the handle as-
sembly switch mount bracket (Fig. 25).
When the parking brake latch is not applied, the latch is
positioned near the target end of the parking brake latch
switch so the switch is closed. The parking brake latch
is moved away from the switch when the latch is applied
causing the switch to be in its normally open state.
Parking Brake Latch Switch Adjustment
1. Park machine on level surface and place traction le-
ver in the NEUTRAL position. Turn key switch to the
OFF position and remove key from the switch.
2. Disconnect the battery pack (see Lithium Battery
Pack Connection in the General Information section of
this chapter).
3. Remove console cover from handle to allow access
to parking brake latch switch (Fig. 26).
4. Raise the parking brake lever and engage the park-
ing brake latch.
5. With the parking brake latch engaged, there should
be from 0.000" to 0.090" (0.0 to 2.2 mm) clearance be-
tween the latch and the parking brake latch switch (Fig.
25).
6. If clearance is incorrect, loosen brake latch switch
mounting fasteners, adjust clearance and tighten fas-
teners. Recheck clearance between lever and switch af-
ter tightening fasteners. The parking brake latch should
rotate freely past the switch.
7. When brake latch switch adjustment is completed,
install console cover to handle.
8. Connect the battery pack (see Lithium Battery Pack
Connection in the General Information section of this
chapter).
Electrical System
1. Service brake lever
2. Park brake latch switch
3
6
RIGHT
FRONT
1. Park brake latch switch
2. Switch panel
3. Lower handle
4. Screw (2 used)
Page 4 - - 22
1
Figure 25
3. Parking brake latch
2
5
7
Figure 26
5. Lock nut (2 used)
6. Console cover
7. Screw (4 used)
Greensmaster eFlex 1800/2100
3
2
1
4