Disengaging Drum Drive From Transmission - Toro Greensmaster eFlex 1800 Service Manual

Disengaging Drum Drive From Transmission

The traction drum is driven by a multi--ribbed belt that is
tensioned with a spring loaded idler assembly. To disen-
gage the traction drum drive from the transmission, fol-
low the following procedure:
1. Park machine on level surface. Turn key switch to the
OFF position and remove key from the switch. Discon-
nect the battery pack (see Battery Pack Connection in
this section).
2. Locate the traction engage/disengage lever next to
the RH drive housing drum (Fig. 2).
CAUTION
Be careful when rotating the traction engage/dis-
engage lever. The lever is spring loaded and may
cause personal injury. Push lever from the front
when removing belt tension to prevent unex-
pected movement of the lever.
3. Rotate traction engage/disengage lever toward the
rear of the machine to the disengaged position to re-
move tension from the drum drive belt.
4. To engage the drum drive, rotate traction engage/
disengage lever to the engaged position by rotating the
lever toward the front of the machine.
5. Connect the battery pack (see Battery Pack Connec-
tion in this section).
Traction and Reel Drive System
1. Traction lever (engaged)
Page 3 - - 4
1
Figure 2
2. RH handle clamp
Greensmaster eFlex 1800/2100
2