Adjustments; Traction Cable Adjustment; Speed Control Adjustment - Toro Hydroject 3010 Service Manual

Adjustments

Traction Cable Adjustment (Fig. 12)
1. Park machine on a level surface, stop the engine and
open the hood. Remove lower cover from handle.
2. Adjust pump end of push-pull cable with pump lever
in neutral starting position by adjusting jam nuts so
distance from seal to threads is 1.00 r 0.05 in.
3. Adjust jam nuts at tiller end of push-pull cable so
traction handle is centered on control handle.
Speed Control Adjustment (Fig. 13)
1. Park machine on a level surface, stop the engine and
open the hood.
2. Adjust speed control cable (Item 26) so speed stop
lever (Item 9) can move to horizontal position.
24
Hydroject 3010
1
2
28
29
30 28
27
1
1. Jam nuts - pump end
3. Adjust speed rods (Item 14) so rod end mounting
holes in pivot arms (Items 11, 23) are located vertically
in line with pivot pin (Item 22).
3
4
5
6
7
8
9
8
10
8
11
12
19
20
24
19
8
26
25
Figure 13
Page 4 - 11
2
Figure 12
2. Jam nuts - tiller end
17
16
13
15
14
13
18
19
20
15
21
8
22
18
23
Adjustments