Drum Drive Belt - Toro Greensmaster eFlex 1800 Service Manual

Drum Drive Belt

See text for
tightening
procedure
4
2
2
1. Drum drive cover
2. Washer head screw (7 used)
3. Gasket
4. Wave washer
5. Gear assembly
6. Retaining ring
The drum drive system on eFlex 1800 and eFlex 2100
machines uses a multi--ribbed poly--V drive belt on the
right side of the traction drum.
Removal (Fig. 19)
1. Park machine on level surface. Turn key switch to the
OFF position and remove key from the switch. Discon-
nect the battery pack (see Battery Pack Connection in
the General Information section of this chapter).
2. Remove transport wheels if attached (see Transport
Wheels in the Service and Repairs section of Chapter 6
-- Chassis and Controls).
Traction and Reel Drive System
9
6
5
3
1
7. Brake band
8. Brake mount pin
9. Extension spring
10. Drum drive belt
11. Brake clevis pin
12. Drum drive housing
12
11
10
8
7
Figure 19
3. Rotate traction engage/disengage lever to the disen-
gaged position to remove tension from the drum drive
belt (Fig. 20) (see Disengaging Drum Drive From Trans-
mission in the General Information section of this chap-
ter).
4. Remove seven (7) washer head screws that secure
the drum drive cover. Remove cover to expose the trac-
tion drive belt.
5. Remove and discard gasket (item 3) from between
cover and housing.
Page 3 - - 16
17
14
13
15 to 17 ft- -lb
(21 to 23 N- -m)
13. Retaining ring
14. Idler pulley assembly
15. Shoulder screw
16. Idler arm assembly
17. Washer head screw (4 used)
18. Drive pulley (from transmission)
Greensmaster eFlex 1800/2100
18
16
15