Cutting Reel Assembly Removal And Installation - Toro Greensmaster eFlex 1800 Service Manual

Cutting Reel Assembly Removal and Installation

8
10
12
11
7
RIGHT
FRONT
1. Crossmember
2. LH side plate
3. Compression spring (2 used)
4. Shoulder bolt (2 used per side plate)
5. Flange nut (2 used per side plate)
6. Cutting reel assembly
NOTE: This section provides the procedure for remov-
ing and installing the cutting reel assembly (cutting reel,
flocked seals, reel bearings, bearing lock screw and reel
nut) from the cutting unit. Refer to Cutting Reel Assem-
bly Service in this section for information on servicing
the cutting reel assembly.
Cutting Unit
210 to 240 in- -lb
(24 to 27 N- -m)
4
9
5
3
6
7. RH pitch arm
8. Flange head screw (2 used)
9. RH side plate
10. Weight
11. Hex nut
16
13
5
5
15
Figure 34
NOTE: EFlex 2100 cutting units use shoulder bolts
(item 4) and flange nuts (item 5) to secure the side plates
to the crossmember as shown in Figure 34. On eFlex
1800 cutting units, square nuts are used instead of
flange nuts. Cutting unit service procedures are the
same on both models.
Page 6 - - 22
eFlex 2100 Shown
210 to 240 in- -lb
(24 to 27 N- -m)
1
5
2
14
3
12. O- -ring
13. Grass shield
14. Flat wire spring
15. LH pitch arm
16. Sensor target plate
Greensmaster eFlex 1800/2100
4