Transmission Drive System - Toro Greensmaster eFlex 1800 Service Manual

Transmission Drive System

15
18
2
See text for
tightening
procedure
RIGHT
FRONT
1. Motor adapter
2. Washer head screw (4 used)
3. Wave washer
4. Ball bearing
5. Retaining ring
6. Splined coupler
Transmission removal from the machine is not neces-
sary to service the transmission drive system shown in
Figure 44. Transmission drive components can be ac-
cessed by removing the battery pack from the frame, re-
moving the electric motor from the transmission,
removing the transmission cover and then removing the
drive belt.
Disassembly (Fig. 44)
1. Park machine on level surface. Turn key switch to the
OFF position and remove key from the switch. Discon-
nect the battery pack (see Battery Pack Connection in
the General Information section of this chapter).
Traction and Reel Drive System
17
21 to 25 ft- -lb
(29 to 33 N- -m)
1
4
7. Drive spline
8. Driven pulley
9. Ball bearing
10. Flocked bearing shield
11. Wave spring
12. Flat washer
Page 3 - - 36
16
6
7
Figure 44
2. Remove electric motor from machine (see Electric
Motor in the Service and Repairs section of Chapter 4
-- Electrical System).
3. Remove transmission drive belt (see Transmission
Drive Belt in this section). Make sure that wave washer
(item 3) remains in bearing bore of transmission cover.
4. Slide driven pulley assembly (including bearings)
from motor adapter.
5. If necessary, remove four (4) washer head screws
(item 2) that secure motor adapter (item 1) to transmis-
sion housing and remove adapter from housing.
Loctite #242
5
9
8
3
11
13
13. Retaining ring
14. Set screw
15. Electric motor assembly
16. Transmission housing
17. Flange head screw (2 used)
18. O- -ring
Greensmaster eFlex 1800/2100
10
12
14