Grooming Reel Service - Toro Greensmaster eFlex 1800 Service Manual

Grooming Reel Service

Inspect grooming reel blades frequently for damage and
wear. Straighten bent blades with a pliers. Replace
blades that are worn or damaged.
Carbide tipped grooming blades (Fig. 16) should be re-
placed if the carbide tip is worn, loose or missing. Also,
if the blade is eroded around the carbide insert, the
blade should be replaced.
Grooming blades without a carbide tip (Fig. 17) should
be replaced if worn or damaged. Blades without a car-
bide tip that are rounded to the midpoint of the blade tip
can be reversed on the grooming shaft to extend the life
of the blade.
Disassembly (Fig. 15)
1. Remove grooming reel from cutting unit (see Groom-
ing Reel Removal (Forward Rotating or Counter Rotat-
ing) in this section).
2. Remove lock nut from either end of the shaft (Fig.
15).
IMPORTANT: If grooming reel is equipped with car-
bide tipped blades, note position of blades on
groomer shaft as they are removed. Correct direc-
tion of blades is required for proper groomer opera-
tion.
3. Remove spacers and blades from groomer shaft as
necessary.
Assembly (Fig. 15)
1. Start by placing thick spacer against the lock nut
installed on one end of groomer shaft. Then, place first
blade against installed spacer (Fig. 15).
IMPORTANT: If groomer is equipped with blades
with carbide tips, make sure that blades are
installed with the tips in the same, correct direction.
2. For 1/2 inch (1.3 cm) blade spacing, make sure there
are two (2) blade spacers between blades (Fig. 15).
3. When all blades have been installed, place second
thick spacer on shaft and then thread second lock nut
onto the shaft.
4. Position lock nuts to allow blades and spacers to be
centered on the shaft (Fig. 18). Torque lock nuts from
200 to 250 in- -lb (23 to 28 N- -m) so spacers are not free
to rotate.
5. Install grooming reel back onto cutting unit (see
Grooming Reel Installation (Forward Rotating or Count-
er Rotating) in this section).
Greensmaster eFlex 1800/2100
1
1. Grooming reel shaft
2. Groomer blade
3. Blade spacer
1
1. Grooming blade
1
1. Grooming blade
2. Sharp edge
CENTER BLADES ON SHAFT
1
1. Lock nut
Page 7 - - 17
200 to 250 in- -lb
(23 to 28 N- -m)
6
2
4
3
Figure 15
4. Thick spacer (2 used)
5. Lock nut (2 used)
6. O- -ring
2
ROTATION
Figure 16
2. Carbide tip
2
ROTATION
Figure 17
3. Dull (rounded) edge
Figure 18
2. Grooming shaft
Groomer
5
3
2