Adjustments; Adjust Shift Tower - Toro Greens Aerator Service Manual

Adjustments

Adjust Shift Tower

If the shift tower on the front of the aerator frame is not
positioned correctly, the shift lever will not properly en -
gage the transaxle gears. Perform the following proce-
dure to position the shift tower is transaxle shifting is
difficult.
1. Park machine on a level surface, fully raise coring
head, stop engine and remove key from the ignition
switch.
2. Raise lock–up brackets on each side of machine and
lower coring head until it rests on brackets.
3. Position shift lever into the neutral slot in shift tower.
4. Loosen four (4) cap screws, flat washers and lock
nuts that secure shift tower to machine (Fig. 1).
5. While rotating drive pulley on transaxle, adjust posi -
tion of shift lever and shift tower until sprockets on trans-
axle output shafts do not move.
6. Secure shift tower in position with four (4) cap
screws, flat washers and lock nuts.
Greens Aerator
1
2
3
1. Shift tower
2. Cap screw (4 used)
Page 7 – 3
4
Figure 1
3. Flat washer (4 used)
4. Lock nut (4 used)
Drive Train