Adjustments; Cutting Unit Clip Adjustment - Toro Greensmaster eFlex 1800 Service Manual

Adjustments

Cutting Unit Clip Adjustment

Cutting unit clip adjustment on the eFlex 1800 and eFlex
2100 can be changed by installing the cutting unit drive
pulleys to the appropriate locations on the reel drive as-
sembly. Clip frequency pulley locations for 11 blade and
14 blade cutting units are shown in Figure 11 below.
To adjust clip frequency, follow the following steps:
1. Park machine on level surface. Turn key switch to the
OFF position and remove key from the switch. Discon-
nect the battery pack (see Battery Pack Connection in
the General Information section of this chapter).
2. Remove reel drive cover and reel drive belt from side
of cutting unit (see Reel Drive Belt in the Service and Re-
pairs section of this chapter).
3. Loosen two (2) set screws from drive pulleys that are
to be removed. Slide pulleys from shafts.
4. Apply antiseize lubricant to top of woodruff keys. Ar-
range pulleys on reel drive assembly as needed for de-
sired clip frequency (Fig. 11).
5. Secure all pulleys with two (2) set screws. Torque
screws from 60 to 65 in- -lb (6.8 to 7.3 N- -m).
6. Install reel drive belt and reel drive cover to cutting
unit (see Reel Drive Belt in the Service and Repairs sec-
tion of this chapter).
7. Connect the battery pack (see Battery Pack Connec-
tion in the General Information section of this chapter).
Traction and Reel Drive System
BLADES POSITION
11 14 A B C
0.147 0.115 22 24 25
0.153 0.120 22 25 24
0.160 0.126 24 22 25
0.174 0.137 25 22 24
0.182 0.143 24 25 22
0.190 0.149
25 24 22
1. Reel drive cover
2. Reel drive belt
3. Pulley
B
A
SET SCREW
60 - - 65 IN LBS
22 TOOTH PULLEY IS ALUMINUM COLOR
24 TOOTH PULLEY IS BLACK COLOR
25 TOOTH PULLEY IS RED COLOR
Figure 11
Page 3 - - 8
60 to 65 in- -lb
(6.8 to 7.3 N- -m)
Antiseize
Lubricant
4
3
5
2
Figure 10
4. Set screw
5. Woodruff key
C
Greensmaster eFlex 1800/2100
1