Toro Greensmaster eFlex 1800 Service Manual page 41

Assembly (Fig. 30)
1. If ball bearing was removed from either cover or
housing, press new ball bearing into bearing bore. Make
sure that bearing is fully pressed to shoulder of bore.
2. Place cover (with bearing installed) on workbench.
3. Slide each pin with gears and spacers into cover.
Make sure that projections on inside of cover are aligned
with the pins that have one (1) gear (Fig. 33).
4. Position housing onto assembly making sure that pin
with one (1) gear is positioned next to index mark on
housing (Fig. 32). Also, align index marks on housing
and cover during assembly (Fig. 31).
5. After housing is installed, use one of the spur gears
(see Differential Assembly in this section) to rotate dif-
ferential gears making sure that they rotate freely with-
out binding. If binding is noted, identify and correct
cause before securing the cover.
6. Secure cover to housing with six (6) socket head
screws. Torque screws from 99 to 121 in- -lb (11.2 to
13.6 N- -m).
7. Pack differential housing cavity 20% to 30% full of
high temperature Mobil XHP--222 grease (or equiva-
lent).
8. Install differential assembly to machine (see Differ-
ential Assembly in this section).
Greensmaster eFlex 1800/2100
2
1
1. Cover index mark
3
2
3
2
1. Housing index mark
2. Pin with 2 gears
2
3
2
1. Projection on cover
2. Pin with 2 gears
Page 3 - - 27
Figure 31
2. Housing index mark
1
2
3
Figure 32
3. Pin with 1 gear
3
1
Figure 33
3. Pin with 1 gear
Traction and Reel Drive System
2
3