Traction Switch - Toro Greensmaster eFlex 1800 Service Manual

Traction Switch

5
RIGHT
FRONT
1. Traction switch
2. Engagement lever assembly
3. Lower handle
The traction switch is a normally open proximity switch.
This switch is one of several inputs for the TEC control-
ler. The switch is attached to the handle assembly switch
mount bracket (Fig. 41).
When the traction engagement lever is not engaged, the
head of the cap screw in the traction lever is positioned
away from the target end of the traction switch so the
switch is in its normal open state. The head of the cap
screw in the traction engagement lever is moved toward
the switch target when the traction lever is engaged
causing the switch to close.
Electrical System
2
8
1
4
4. Washer head screw (2 used)
5. Lock nut (2 used)
6. Console cover
3
6
Figure 40
Check Traction Switch Operation
Check traction switch operation with the InfoCenter on
the console. With the key switch in the RUN position and
the InfoCenter in the Diagnostics menu, choose Trac-
tion and make sure that the switch state changes as the
traction lever is applied and released. Further traction
switch testing is necessary only if the switch state does
not change when using the InfoCenter.
Page 4 - - 32
7
7. Washer head screw (4 used)
8. Switch mount bracket
Greensmaster eFlex 1800/2100