Reel Engage Switch; Electrical System - Toro Greensmaster eFlex 1800 Service Manual

Reel Engage Switch

The reel engage switch is a normally open proximity
switch. The switch is attached to the handle assembly
switch mount bracket (Fig. 29).
When the cutting reel is not engaged, the tab on the cut-
ting reel engagement lever is positioned away from the
target end of the reel engage switch so the switch re-
mains open. The tab on the engagement lever is moved
next to the switch when the cutting reel is engaged caus-
ing the switch to close.
Reel Engage Switch Adjustment
1. Park machine on level surface and place traction le-
ver in the NEUTRAL position. Turn key switch to the
OFF position and remove key from the switch.
2. Disconnect the battery pack (see Lithium Battery
Pack Connection in the General Information section of
this chapter).
3. Remove console cover from handle to allow access
to reel engage switch (Fig. 30).
4. Move the engagement lever forward to the cutting
reel engagement position.
5. With the engagement lever in the cutting reel drive
engagement position, there should be from 0.030" to
0.090" (0.8 to 2.2 mm) clearance between the tab on
the cutting reel engagement lever and the reel engage
switch (Fig. 29).
6. If clearance is incorrect, loosen reel engage switch
mounting fasteners, adjust clearance and tighten fas-
teners. Recheck clearance between lever tab and
switch after tightening fasteners. The tab on the cutting
reel engagement lever must not contact the switch.
7. When reel engage switch adjustment is completed,
install console cover to handle.
8. Connect the battery pack (see Lithium Battery Pack
Connection in the General Information section of this
chapter).

Electrical System

1
3
2
1. Engagement lever
2. Reel engage switch
2
8
4
1
5
RIGHT
FRONT
1. Reel engage switch
2. Engagement lever assy
3. Lower handle
4. Screw (2 used)
Page 4 - - 24
Figure 29
3. Lever tab
3
6
Figure 30
5. Lock nut (2 used)
6. Console cover
7. Screw (4 used)
8. Switch mount bracket
Greensmaster eFlex 1800/2100
7