Transmission Drive Belt - Toro Greensmaster eFlex 1800 Service Manual

Transmission Drive Belt

1
RIGHT
FRONT
1. Transmission assembly
2. Transmission belt
3. Gasket
Transmission removal from the machine is not neces-
sary to service the transmission drive belt. The trans-
mission drive belt can be replaced by removing the
battery pack from the frame, removing the transmission
cover and then removing the drive belt.
Drive Belt Removal (Fig. 34)
1. Park machine on level surface. Turn key switch to the
OFF position and remove key from the switch. Discon-
nect the battery pack (see Battery Pack Connection in
the General Information section of this chapter).
2. Remove battery pack from machine (see Battery
Pack in the Service and Repairs section of Chapter 4 --
Electrical System).
3. Use tips of needle nose pliers to spread ends of drive
shaft wire (item 7) in telescoping coupler (item 8). With
wire ends spread, slide coupler from transmission shaft.
Traction and Reel Drive System
4
2
3
Figure 34
4. Wave washer (2 used)
5. Transmission cover
6. Washer head screw (7 used)
Page 3 - - 28
4
7. Drive shaft wire
8. Telescoping coupler
IMPORTANT: During disassembly, make sure that
tension is released from transmission belt before
removing transmission cover.
4. Remove tension on transmission belt by rotating the
engage/disengage shaft clockwise (see Transmission
Belt Tensioner in the General Information section of this
chapter).
5. Remove seven (7) washer head screws that secure
transmission cover to transmission. Carefully remove
cover from transmission. Remove and discard gasket
(item 3).
6. Make sure that wave washers (item 4) remain in
bearing bores of transmission cover.
7. Note transmission belt routing for assembly pur-
poses (Fig. 35).
See text for
tightening
procedure
6
5
7
8
Greensmaster eFlex 1800/2100