Toro Greensmaster eFlex 1800 Service Manual page 173

2. Install LH support plate to left side of cutting unit:
A. Apply antiseize lubricant to threads of LH groom-
er arm lift rod.
B. Position support plate to cutting unit making sure
that LH groomer arm lift rod is positioned through
bushing in support plate.
C. Place spring washer and lock nut on lift rod
threads (Fig. 20). Tighten lock nut.
D. Install reel drive assembly, reel pulley, reel drive
belt and then reel drive cover to left side of cutting
unit (see Reel Drive Assembly in the Service and Re-
pairs section of Chapter 3 -- Traction and Reel Drive
System).
3. Install grooming reel, front roller and RH drive plate
to right side of cutting unit (see Grooming Reel (Forward
Rotating or Counter Rotating) in this section).
4. Check and adjust grooming reel height and mower
height--of--cut settings.
5. Install cutting unit to the machine.
6. Lubricate groomer bearings.
7. Connect the battery pack (see Battery Pack Connec-
tion in the General Information section of this chapter).
NOTE: After greasing groomer bearings, operate
groomer for 30 seconds, stop machine and wipe any ex-
cess grease from groomer shaft and seals.
Greensmaster eFlex 1800/2100
COUNTER ROTATING GROOMER
2
3
1. RH drive plate assy
2. Bearing (2 used)
Seal lip
(toward center of
cutting unit)
1. LH support plate
2. Bearing
6
8
1. Outer bearing
2. Drive plate shoulder
3. Inner bearing
4. Inner race
Page 7 - - 19
1
3
2
Seal lips
(toward center of
cutting unit)
Figure 22
3. Seal (2 used)
1
4
2
3
Figure 23
3. Seal
4. Plug
2
3
5
5
4
7
Figure 24
5. Seal lip
6. Support plate bearing
7. Drive plate (RH side)
8. Support plate (LH side)
Groomer
1
5