Panasonic KX-TDA600 Feature Manual page 296

Hybrid ip-pbx
Hide thumbs Also See for KX-TDA600:
Table of Contents

Advertisement

1.17 T
1.2.
Time Service
Time modes are used by many PBX features to determine how they will function during different
times of day (→ 1.17.5 Time Service). The start and end times of each time mode (day/lunch/
break/night) for each day of the week are programmed in a Time Table. Each Time Table has a
number which corresponds to the tenant number of the tenant it serves. (Tenant 1 uses Time Table
1, etc.)
[Example of Tenant Configuration]
Tenant 1
Extn. User
Group 1
Extn. User
Group 2
Extn. User
Group 3
Extn. User
Group 4
Uses Time Table 1
2.
System Management
Each of the following system management items can be assigned to each tenant.
a)
Tenant Operator: Determines the destination for calls directed to the tenant's operator. If no
operator is designated, the PBX operator will serve as the tenant's operator. (→ 1.12.5
Operator Features)
→ 2.13.6 [6-6] Tenant—Operator (Extension Number)
b)
ARS Mode: Determines under which circumstances Automatic Route Selection (ARS)
operates for calls made by the tenant's extensions — either when a call is made using the Idle
Line Access method, or when any CO Line Access method is used. (→ 1.3.14 CO Line
Access). The ARS mode for each tenant can also be programmed to be the same ARS mode
assigned to the entire PBX, or turned off. (→ 1.1.3 ARS (Automatic Route Selection))
→ 2.13.6 [6-6] Tenant—ARS Mode
c)
Audio Source for Music on Hold: Determines the audio source for the Music on Hold heard
by the tenant's callers. Either a tone or a specific background music (BGM) number can be
used. The audio source for each tenant can also be programmed to use the same audio
source used for Music on Hold assigned to the entire PBX. (→ 1.11.4 Music on Hold)
→ 2.13.6 [6-6] Tenant—Music On Hold
d)
System Speed Dialing: Determines whether each tenant uses the original set of common
System Speed Dialing numbers or that tenant's private set. (→ 1.16.4 Speed Dialing, System)
→ 2.13.6 [6-6] Tenant—System Speed Dial
Hardware requirement: an EMEC or MEC card
296
Feature Manual
Tenant 2
Extn. User
Group 5
Extn. User
Group 6
Uses Time Table 2

Advertisement

Table of Contents
loading

This manual is also suitable for:

Kx-tda200Kx-tda50Kx-tda100

Table of Contents