Extension Port Configuration - Panasonic KX-TDA600 Feature Manual

2.9.8 [2-6-1] Numbering Plan—Main—Features—Extension PIN Set / Cancel
2.9.17 [2-9] System Options—Option 1—PT LCD—Password / PIN Display
2.11.1 [4-1-1] Wired Extension—Extension Settings—Main—Extension PIN
2.11.10 [4-2-1] Portable Station—Extension Settings—Main—Extension PIN
PT Programming Manual
[005] Extension Personal Identification Number (PIN)
Operating Manual References
3.1.2 Personal Programming
3.2.2 Manager Programming
1.5.7

Extension Port Configuration

Description
There are five types of extension ports, used to connect digital proprietary telephones (DPTs), analog
proprietary telephones (APTs), single line telephones (SLTs), Cell Stations (CSs), DSS Consoles, and Voice
Processing Systems (VPS) to the PBX. The devices which can be connected to each type of port are listed
below.
a)
DPT Port: DPT, DSS Console, Panasonic VPS which supports DPT (Digital) Integration, and PT-
interface CS (e.g., KX-TDA0141)
b)
APT Port (For KX-TDA50 only): APT, DSS Console, and Panasonic VPS which supports DPT
(Digital) Integration
c)
SLT Port: SLT and Panasonic VPS which supports DTMF Integration
d)
Super Hybrid Port: DPT, APT, SLT, DSS Console, Panasonic VPS, and PT-interface CS
e)
Hybrid Port (For KX-TDA50 only): APT, SLT, DSS Console, Panasonic VPS, and PT-interface CS
EXtra Device Port (XDP):
A Super Hybrid port can be used as an XDP port, allowing two telephones (a DPT and an SLT) to be
connected to the same port of the PBX. This XDP port can be used in one of the following modes:
Mode
Parallel Mode
XDP Mode
Conditions
• Automatic Detection on Hybrid/Super Hybrid Port
A DPT, SLT, or PT-interface CS connected to a Super Hybrid port or an APT, SLT or PT-interface CS
connected to a Hybrid port can be detected automatically without any programming. An APT connected
to a Super Hybrid port can be detected automatically when XDP mode has been disabled.
The DPT and an SLT share the same extension number so that they
can act as one extension. The SLT uses the extension data (extension
number, Class of Service [COS], etc.) of the DPT. (→ 1.13.2 Paralleled
Telephone)
The DPT and SLT have different extension numbers and act as
independent extensions. To use XDP mode, XDP mode must be
enabled for the port through system programming. (→ 1.13.2
Paralleled Telephone)
Description
Feature Manual
1.5 E
95