Installing The Sim Card-I/O X-Card Present - Sierra Wireless AirLink GX Series Hardware User's Manual

Rev 8 Nov.15
SMA antenna connector
Figure 2-6: Replacing the screws, nut, and washer (Wi-Fi X-Card installed)
10. Place the lock washer onto the SMA antenna connector and move it to the
back of the connector, so it is touching the decorative black cover.
11. Install, then tighten the nut with a 5/16" or 8 mm socket torque wrench to a
torque specification of 8in-lbs (0.9 N-m).
Installing the SIM Card—I/O X-Card present
Important:
Failure to follow these instructions carefully may damage the X-Card and
void the warranty agreement.
To install a SIM card in a GX Series gateway with an I/O X-Card installed:
1. Unscrew the two 4-40 male to female hexagonal threaded standoffs (jack
screws) on either side of the serial port at the front of the gateway, using the
socket and wrench. Keep the hexagonal threaded standoffs for reinstallation.
2. Remove the four screws used to secure the black decorative cover. Use a
2 mm Allen (hex) wrench or a Phillips #1 screwdriver, depending on the screw
type used on the decorative black cover. Save the screws for reinstallation.
lock washer
hexagonal nut
Installation and Startup
21