Installing The Sim Card-Wi-Fi X-Card Present - Sierra Wireless AirLink GX Series Hardware User's Manual

AirLink GX Series Hardware User Guide
18
Installing the SIM Card—Wi-Fi X-Card present
Important:
Failure to follow these instructions carefully may damage the X-Card and
void the warranty agreement.
To install a SIM card in a GX Series gateway with a Wi-Fi X-Card installed:
1. Unscrew the 8 mm hexagonal nut on the Wi-Fi SMA antenna connector at the
front of the gateway, using the socket and wrench. Then slide off the nut and
lock washer. Save the nut and washer. These are used again.
2. Remove the four screws used to secure the black decorative cover. Use a
2 mm Allen (hex) wrench or a Phillips #1 screwdriver, depending on the screw
type used on the black decorative cover. Save the screws for reinstallation.
SMA antenna connector
Figure 2-2: Removing the screws, nut and washer (Wi-Fi X-Card installed)
3. Gently tilt up the back of the decorative black cover and then move the cover
forward so that it slides over the Wi-Fi SMA antenna connector.
lock washer
hexagonal nut
4114008