Mounting The Gx Series - Sierra Wireless AirLink GX Series Hardware User's Manual

Rev 8 Nov.15
7. Use the 4 screws saved in step 1 to re-attach the decorative black cover.
Torque the screws to 5 in-lb. (0.6 N-m). Ensure that the screws are tight so
that the seal underneath the decorative black cover is tight against the
gateway.
black gasket around
the Ethernet ports
Figure 2-16: Replacing the screws (Dual Ethernet X-Card installed)

Mounting the GX Series

Warning:
This gateway is not intended for use close to the human body. Antennas
should be at least 8 inches (20 cm) away from the operator.
Note: The gateway has a hardened case for use in industrial and extreme environments. If
you are installing it in these types of environments, use cables designed and specified for
use in these types of environments to avoid cable failure.
Mount the gateway where:
• There is easy access to the cables
• Cables are not bent, constricted, close to high amperages or exposed to
extreme temperatures
• Cables are secured to ensure reliable connections
• The front panel LEDs are easily visible
• There is adequate airflow
Installation and Startup
27