Installing The Sim Card-Dual Ethernet X-Card Present - Sierra Wireless AirLink GX Series Hardware User's Manual

Hide thumbs Also See for AirLink GX Series:
Table of Contents

Advertisement

AirLink GX Series Hardware User Guide
24
tight so that the seal underneath the decorative black cover is tight against
the gateway.
9. Re-install the screw nuts you saved in step 1 to either side of the serial port.
(Finger tight is sufficient.)
Note: The screw nuts must be re-installed to maintain the IP rating for the AirLink gateway.
screw nuts
Figure 2-11: Replacing the screws and nuts (I/O X-Card installed)
Installing the SIM Card—Dual Ethernet X-Card
present
Important:
Failure to follow these instructions carefully may damage the X-Card and
void the warranty agreement.
To install a SIM card in a GX Series gateway with a Dual Ethernet X-Card
installed:
1. Remove the four screws used to secure the black decorative cover. Use a
2 mm Allen (hex) wrench or a Phillips #1 screwdriver, depending on the screw
type used on the black decorative cover. Save the screws for reinstallation.
4114008

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents