Installing The Sim Card-Wi-Fi X-Card Present - Sierra Wireless AirLink GX450 Hardware User's Manual

AirLink GX450 Hardware User Guide
Installing the SIM Card—Wi-Fi X-Card present
Important:
warranty agreement.
To install a SIM card in a GX450 gateway with a Wi-Fi X-Card installed:
1. Unscrew the 8 mm hexagonal nut on the Wi-Fi SMA antenna connector at the front of
2. Remove the four screws used to secure the black decorative cover. Use a 2 mm Allen
3. Gently tilt up the back of the decorative black cover and then move the cover forward
Rev. 11 July 2019
Failure to follow these instructions carefully may damage the X-Card and void the
the gateway, using the socket and wrench. Then slide off the nut and lock washer.
Save the nut and washer. These are used again.
(hex) wrench or a Phillips #1 screwdriver, depending on the screw type used on the
black decorative cover. Save the screws for reinstallation.
SMA antenna connector
Figure 2-2: Removing the screws, nut and washer (Wi-Fi X-Card installed)
so that it slides over the Wi-Fi SMA antenna connector.
lock washer
hexagonal nut
16 4114008