Sound Settings For Calls; Set Ring Volume; Set Ring Signal - ASCOM d81 Configuration Manual

Configuration Manual
Ascom d81 DECT Handset
• Man-down warning angle
Determines the angle the handset must be tilted to trigger the Man-down alarm.
• No-movement alarm
Determines if the No-movement alarm is enabled or disabled.
• No-movement detection time
Determines when the warning phase starts after No-movement alarm is triggered.
• Warning phase duration
Determines the time before the warning phase is ended and the alarm is sent.
• NM-MD extra delay used
Determines if detection time for man-down and no-movement alarms are extended.
• NM-MD extra delay time
Determines how long time the extended detection time is for man-down and no-
movement alarms.
1
• ALS
• Mode for automatic call after alarm
The call can be established in the following modes;
- Off: No automatic call after alarm
- Normal: the call is established as an ordinary call.
- Loudspeaking: the loudspeaker on the backside of the handset is turned on.
- Monitoring: a one-way speech channel is established, that is, the called part can only
listen to an conversation.
• Turn off NM-MD during call
Determines if the Man-down alarm and No-movement alarm is disabled during a call.
See also 5.26 Common Alarm Settings
Information about the handset's location can also be sent along with an alarm, see
Base Station Location

5.30 Sound Settings for Calls

The ring volume and ring signal for calls can be set.

5.30.1 Set Ring Volume

1 Select Settings > Sound and Alerts.
2 In the Ring Volume drop-down list, select the ring volume to be used.

5.30.2 Set Ring Signal

1 Select Settings > Sound and Alerts.
2 In the call drop-down lists, select the ring signal to be used for the different calls.
3 In the Internal Call/External Call/Callback/PTT Call drop-down lists; select the ring
signal to be used for the incoming call, respectively.
Tip: Create own ring signals can be created and then selected. See
Custom Sound as Ring
1. The ALS is not activated if an automatic call is established after an alarm has been sent.
29 April 2015 / Ver. I
5. Handset Configuration
on page 37 for additional parameter settings.
on page 32 and 5.22 DECT Location and LF Location
Signal.
TD 92674EN
5.21
on page 33.
5.30.3 Create
40