Disable Homebase Gap Registration; Require Encrypted Base Station; Early Encryption; Base Station Location - ASCOM d81 Configuration Manual

Configuration Manual
Ascom d81 DECT Handset

5.18 Disable Homebase GAP Registration

When the feature is enabled, it is not possible to register to a home base.
Using the "Edit template" feature in the PDM/Device Manager, the parameter can be found
at
Systems > Home_Base_Subscription.
The parameter is set to "Enable" for registration of a new base station. The default value is
"Disable".

5.19 Require Encrypted Base Station

The handset can be configured to set up calls via encrypted base stations only. This is used
to avoid snooping in the telephony network.
Requirements:
• The encryption is enabled in the base station. See corresponding manual for the base
station.
• If Ascom´s base station is used, the software version must be 3.1.x or higher.
Using the "Edit template" feature in the PDM/Device Manager, the parameter can be found
at:
Systems > Encryption required.
When the parameter is set to "Yes", only call setup via encrypted base stations are possible.
The default value is "No".

5.20 Early Encryption

Early encryption is used when enhanced DECT security is activated in the base station. This
means that the radio link is encrypted early before data is transmitted.
To enable early encryption in the handset, the "Early encryption enable" parameter is set via
the PDM in the following way:
1 From the PDM/Device Manager, select Systems > System x
2 Select "true" from the Early Encryption enable drop-down list
If users experience connection problems when early encryption is turned on, the function
may be turned off in the handset by reconfiguring the handset through the PDM and setting
the value of the parameter to "false". This can occur, for example, when the handset is being
used in an environment where highly reflected metallic surfaces are used in the construction
of the locale.

5.21 Base Station Location

The approximate location of the handset can be sent with an alarm. The handset evaluates
the field strength ratio of the individual radio base stations and sends the best-rated Base
Station ID to indicate an approximate location of the handset.
In addition, a system can also request the Base Station ID regardless of whether or not an
alarm is sent. See
To send the base station location with an alarm, the "Base station positioning" parameter is
set to "On". The parameter is accessed through the PDM/Device Manager at:
Alarm > Location > Base station positioning
Note: The standby time for the handset is lower when base station location is activated.
29 April 2015 / Ver. I
5. Handset Configuration
5.24 Poll Location on page 36.
TD 92674EN
32