Configuration Manual
Ascom d81 DECT Handset
No flash driver was found
Note: This display message is
only shown in English.
SERVICE NEEDED
Hardware error
Note: This display message is
only shown in English.
SERVICE NEEDED
Invalid IPDI
Note: This display message is
only shown in English.
Enter PIN code
Battery low, charge now
Phonebook is not available at
the moment.
Voicemail number not defined There is no voicemail number
Could not encrypt connection The parameter "Encryption
License key not accepted
29 April 2015 / Ver. I
7. Troubleshooting
Failed to read from flash
There is a communication
problem between
components in the handset.
Easy replacement procedure
not followed correctly or
failure during easy
replacement procedure.
Phone lock is activated.
The battery level is low.
The phonebook is not
activated or does not
respond.
defined in the handset.
Required" is enabled in the
handset in combination with;
1) Unencrypted base
station(s); and/or,
2) Unsupported base
station(s).
1)The license key is to short/
long.
2) The license key is not valid.
TD 92674EN
Send the handset for service.
Restart the handset. If the
problem persists, send the
handset for service.
Send the handset for service.
Enter the required PIN code. If
the PIN code has been lost,
enter a new PIN code via the
PDM/Device Manager or do a
factory reset via the PDM/
Device Manager.
Charge the handset, or
replace or charge the battery.
Try again later or if the fault
persists do a factory reset via
the admin menu or via the
PDM/Device Manager.
Note that it may take several
minutes for the phonebook to
be available if there are many
entries in Contacts and/or
company phonebook.
Define a voicemail number via
the PDM/Device Manager.
1) Disable the "Encryption
Required" parameter in
handset; and/or,
2) Enable the encryption in
the base station(s); and/or,
Note: If Ascom's base
station(s) is used, the
software version must be
3.1.x or higher.
3) Use supported base
station(s). Ask your supplier.
1)Make sure that the license
key consists of 29 digits.
2) Generate a valid license
using the License Web.
66
Need help?
Do you have a question about the d81 and is the answer not in the manual?
Questions and answers