ASCOM d81 Configuration Manual page 49

Configuration Manual
Ascom d81 DECT Handset
• Call priority
This parameter determines:
- whether call information presented on the display during incoming, ongoing and
outgoing call is suppressed when viewing a message
- whether an ongoing call is disconnected when receiving a PTT invitation with Answer
mode set to "Automatically".
0 = Call indication overrides all messages and ongoing call is never disconnected
(default).
1-9 = Comparison with message priority; highest priority is shown and PTT invitation
with higher priority causes disconnection of ongoing call.
10 = Call indication on the display is always suppressed and ongoing call is always
disconnected by a PTT invitation.
The tables below show examples of priority settings and how they affect the handset
behaviour.
Call priority
0
6
2
3
10
10
a.PTT invitation received as incoming call has always priority 6, while PTT invitation received as message
can have priority 1 - 9 depending on configuration.
Table 3. Call priority vs PTT priority
Call priority
0
7
6
1
10
Table 4. Call priority vs Message priority
29 April 2015 / Ver. I
5. Handset Configuration
PTT invitation Disconnection of ongoing call?
a
(priority)
1 No, since this call priority setting overrides all
PTT invitations regardless of priority.
6 No, an ongoing call is not disconnected when
the priority is equal.
1 Yes, immediately since the PTT priority is set to
1 and also is higher than Call priority.
2 Yes, after 10 seconds since the PTT priority is
higher than Call priority.
1 Yes, immediately since the PTT priority is set to
1 and also is higher than Call priority.
2 Yes, after 10 seconds since the PTT priority is
higher than Call priority.
Displayed Message Call information suppressed?
(priority)
1 No, since this call priority setting overrides all
messages regardless of priority.
6 Yes, since the priority of the displayed
message is higher than the incoming call.
6 Yes, since the message is considered as most
important when the priority is equal.
3 No, since the priority of the incoming call is
higher than the displayed message.
Yes, the call information is always suppressed
1
regardless of the message priority.
TD 92674EN
43