Installing The Control; Mounting The Cabinet; Installing The Cabinet Lock - ADEMCO Vista-20 Installation Instructions Manual

This section provides instructions for mounting the control cabinet, and
installing the cabinet lock (if used). Also included in this section are
instructions for the following
Installing the main PC board.
" Mounting the 5881 (5882 in Canada) RF Receiverboard in the cabiuet (if
used)
Standard phone line connections.
c Instalhg the back-up battery in the"cabinet.
Connecting the AC tmnsformer.
Making earth ground connections.
Mounting the Cabinet
Mount the control cabinet to a sturdy wall using fasteners or anchors (not
supplied), in a clean, dry area which is not readily accessible to the general
public. Four mounting holes are provided at the back of the cabinet.
If an RF Receiveris being used and you intend to mount its PC board within
the cabinet, note the following
" Do not mount the cabineton or nesr metal objects.This will decreaseRF
range andlor block RF hnsmissions fkomwirelesstransmitters.
s Do not locatethe cabinetin an area of high RF interference (revealed by
frequent or prolonged lighting of the LED in the receiver after it is
operational (random flicker is OK).
instalhg the Lock (ii need)
Use an Ademco No. N6277 Cam
(Retainer Clip).
Note: The cabinet can be closed
screwsin the cover'sedge.
Lock and No. N6277-1 Push-On Clip
and secured
without
a lock by using 2
k
Figure
1. InetaUbg
The Cebiiet Lock
1,
2.
3.
Removethe cabinet door.It is
easily removable for servicing
and is easily re-installed.
Remove the lock knockout
fkomthe control cabinet door.
Insert the key into the lock.
Position the lock in the hole
making certain that the latch
will make contact with the
latch bracketwhen the door is
closed.
Hold the lock steady, and in-
sert the retainer clip into the
retainer slots. Position the
clip as illustrated in order to
permit easyremoval.
-12-