Section 4 - Installing The Control; Mounting The Control Cabinet; Installing The Cabinet Lock; Figure 4-1: Installing The Lock - ADEMCO Vista-32FB Installation And Setup User's Manual

• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •
In This Section

Mounting the Control Cabinet

Installing the Cabinet Lock

Grade A Mercantile Premises Listing
Grade A Mercantile Safe and Vault Listing
Installing the Control's Circuit Board
Connecting the AC Transformer and Battery
Panel Earth Ground Connections
• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •
Mounting the Control Cabinet
•
•
Installing the Cabinet Lock
Use an ADEMCO No. N6277 Cam Lock and No. N6277-1 Clip supplied with the panel.
www.PDF-Zoo.com
Mount the control cabinet to a sturdy wall using fasteners or anchors (not supplied) in a
clean, dry area that is not readily accessible to the general public. The back of the control
cabinet has four holes for this purpose.
Before mounting the circuit board, remove the metal knockouts for the wiring entry that
will be used. DO NOT ATTEMPT TO REMOVE THE KNOCKOUTS AFTER THE
CIRCUIT BOARD HAS BEEN INSTALLED.
1. Insert the key into the lock.
Position the lock in the hole,
making certain that the latch
will make contact with the
latch bracket when the door is
closed.
2. While holding the lock steady,
insert the retainer clip into the
retainer slots.
Installing the Control
LOCKED
RETAINER
CLIP
UNLOCKED
CABINET DOOR BOTTOM

Figure 4-1: Installing the Lock

S E C T I O N 4
RETAINER CLIP
(NOTE POSITION)
RETAINER
SLOTS
4–1