Adding A Serial Number - ADEMCO Vista-20 Installation Instructions Manual

Use
X83
interactive mode when a wirelessbnsmitter is to be physically added, removed, or
simply changed(as when replacinga unit that has a non-removablebattery).
By using this mode, you can add, delete,or change the serial number of a transmitter in a
zone, but retain all other existingdata that has been progmunrned for that zone.
Certain button type transmitters have more than one button (e.g., 5801). Note that each
button must be assigned to a different zone. Similarly, the 5816 transmitter has contact
termids and a reed switch for use with a magnet. If using both, eachmust also be assigned
to a different zone.
This means that the procedures that follow must be repeated for each button or contact on
the transmitter.
Adding a$arbd Numba
1. With at least one 2-line Alpha keypad (5137AD or 6139) connectedto the
system, power up the system temporarily. If the AC transformer was
previously connectedto the control panel, plug in the transformer (to
120VAC outlet)to power up the system.
2. Enter the programming mode by keying the following on the Alpha
keypad: Installer code (41 12) +8+ O + O.
R%Eil
3
ZoneNumber T
-:
Zone Numberentered ? .
EziE16
Flaehing
cursor
T
Press M. A prompt to enter zone number
will be displayed.
Note:
If a 4219 or 4229 has
not
been used in the
system,wirelesszonesstart at zone
10.
If a 4219 or 4229 has been used in the
system,wirelesszonesstart at zone 18.
Enter the zone number to be learned (e.g.,
zone 18).
Press *to continue,
"RF
is initially displayed. If necessary,refer
temporarily to "5800 Series
Transmitters
Table" in
the
WIRELESS EX.PA.NSION
sectionfor "Input Type" to be entered for each
of the availabletransmitters.
Available Input
Types and their corresponding entries are:
O =
not used.
3 = supervised RF
transmitter (RF type)
4 = unsupervisedRF transmi tter (UR type)
5 = RF button type transmitter (BR me)
When you have entered the appropriate
number for the transmitter being pro-
grammed, press *to continue.
Press
"1" (Yes).
-72-