Mounting The Cabinet; Installing The Lock (If Used); Installing The Control's Circuit Board Alone, Or (If Used),With A 4219, 4229, Or 4204; The Control, Board - ADEMCO via30 Installation Instructions Manual

Mounting the Cabinet
Installing the Lock
(if Used)
m
Installing the Control's
Circuit Board Alone,
or (if used),with a
4219, 4229, or 4204
IMPORTANT!
Before installing the
cabinet's contents, be
sure to remove the ap.
propriate metal cabinei
knockouts.
DO NOT ATTEMPT TO RE.
MOVE THE KNOCKOUTS AF.
TER THE CiRCUiT BOARD HAS
BEEN INSTALLED.
The Aden?co via30 is supplied with a 12-1/2" (318mm) wide x 14-1/2 (368mm) ~
high x 3" (76mm) deep cabinet suitable for use in residential installations.
Mount the control cabinet to a sturdy wail using fasteners or anchors (not
suppiied) in a ciean, dry area
which is not readily accessible to the generai public.
4 mounting holes are provided at the back of the cabinet.
Use an Ademco No. N6277 Cam
Lock and No. N6277-1 Push-On Clip
(Retainer Clip).
\
1. Remove the cabinet cover. /t is
easily removable for servicing
and is easily reinstalled.
LOCKED
2. Remove the lock knockout from
1
RflAINER CLIP
the control cabinet cover. Insert i
the key into the lock. Position i
*
,, m
the iock in the hole making cer-
..:
tain that the iatch wiii make con-
'--'
tact with the latch bracket when
\
the door is closed.
UNLOCKED
3. Whiie holding the lock steady,
insert the retainer clip into the
+
[
RmAINER CLIrJ
,wEPosmoN,
1,
RSAINER
/0, ,
sLOTS
retainer slots.
Position ciip as il-
(~
iustrated to facilitate easy re-
CAOINET DCOR BOITOM
rnoval.
Control's Circuit Board
1.
Hang two /ong mounting ciips (provided) on the raised cabinet tabs (see De-
taii B below).
2. insert the top of the circuit board into the siots at the top of the cabinet. Make ~
sure that the hoard rests on the correct row (see Detaii A ).
3. Swing the base of the board into the mounting clips and secure the board to
the cabinet with the accompanying screws (see Detail B).
4219, 4229 or 4204
1. Insert seif-tapping screws (provided) in two adjacent raised cabinet tabs.
Leave the heads projecting 1/8".
2. Hang the unit on the screw heads via two of the slotted hoies at the rear of its
housing, as shown.
3. The 4219's or 4229's cover can be ieft off if the cover tamper jumper is placed
in its upper (not tampered) position (see Detaii C). The tampered cover is
necessary for installations outside of the control's cabinet. "
I \
\
4219, +
4229,
o r
4204
/q ~p
COVER TAMPER
JUMPER
–14-