Installing Receiver; Rf System Installation Advisories; Installation And Setup Of The 5881/5882 Receiver - ADEMCO Vista-20 Installation Instructions Manual

Installing the 5SS1/58?32 Receiver
RF System
InstaUation
A dvisories
Disregard the following advisories if the receiver is mounted in the control
cabinet as described in Section 2.
1.
2.
3.
4.
Placethe RF Receiverin a high, centrallylocatedarea for best reception.
Do not locate the receiver or transmitters on or near metal objects.This
will decreaserange and/or blocktransmissions.
Do not locatethe receiverin an area of high RF interference(revealed by
frequent or prolonged lighting of the LED in the receiver. . random
flicker is OK).
The RF receiver must be at least 10 feet from any remote keypads to
avoid interferencefrom the microprocessors in those-units.
InstaUation
and Setup of the
5S81/5882 Receiver
4.
Set the receiver's DIP switch for device address "O",as described in its
instructions (all switchesto the right. . . "off").
Mount the receiver.The RF receivercan detectsignalsfrom transmitters
within a nominal range of 200 feet. Take this into consideration when
determining mounting location.
Connectthe receiver'swire harness to the control'skeypad terminals (4,
5, 6, and 7). Plug the connectorat the other end of the harness into the
receiver.
Refer to the installation instructions provided with the receiver for
further installation proceduresregarding antenna mounting, etc.
NOTt2WHEN CIRCUIT BOARD ISMOUNTED IN
TOCONTROL'S
REMOTE KEYPAD
CONNECTION
POINTS.
13gure
12. 5S81/58S2 RF Receiver (cover removed)'
-33-