Chapter 7: Maintenance/Servicing - Titan EHS Operation Manual

7. Maintenance/Servicing
7.1 Replacement of Standard Nut/-Connector and Support Arm
Never use a tool that has been damaged. Use original Titan
• Disconnect power cord from power source
• Place the Titan -Torque Wrench on a flat surface
®
• Remove rubber ring and safety pin/bolt - standard nut
• Remove DMA, loosen securings if necessary
• Reverse operation for replacement
Titan -STACO
®
Standard Nut
SUPERIOR BOLTING SOLUTIONS SUPERIOR BOLTING SOLUTIONS
CAUTION!
Titan -DMA
®
Support Arm resp.
Torque Sensor
25
- parts only.
®
Titan -STABI
®
Standard Connector
www. www.
1.866.345.8484 1.866.345.8484
TITAN TITAN
TI TI
.com .com