General Cleaning; Maintenance - Titan TTB924DBT Manual

Care and maintenance
EN EN
The golden rules for care
WARNING! Always switch the machine off, disconnect the machine
from the power supply and let it cool down before performing inspection,
maintenance and cleaning work!
1. Keep the machine clean. Remove debris from it after each use and before
storage.
2. Regular and proper cleaning will help ensure safe use and prolong the life of
the product.
3. Inspect the machine before each use for worn and damaged parts. Do not
operate it if you find broken and worn parts.
WARNING! Only perform repairs and maintenance work according to
these instructions! All further works must be performed by a qualified
specialist!

General Cleaning

1. Clean the machine with a dry cloth. Use a brush for areas that are hard to
reach.
2. In particular clean the air vents after every use with a cloth and brush.
3. Remove stubborn dust with high pressure air (max. 3 bar).
NOTE: Do not use chemical, alkaline, abrasive or other aggressive
detergents or disinfectants to clean this product as they might be
harmful to its surfaces.
4. Check for worn or damaged parts. Replace worn parts as necessary or
contact an authorised service centre for repair before using the product again.

Maintenance

Before and after each use, check the machine and accessories (or attachments)
for wear and damage. If required, exchange them for new ones as described in
this instruction manual. Observe the technical requirements.
34
MNL_TTB924DBT_350W Drill Press_GB_EU_V1_220421.indd 34 MNL_TTB924DBT_350W Drill Press_GB_EU_V1_220421.indd 34
TTB924DBT by TITAN
2022/4/21 2:54 PM 2022/4/21 2:54 PM