Maintenance; Handy Hints - Titan SF1022 Safety And Operating Manual

loosen
Tighten
Fig 14
Fig 15
Fig 16
(see Fig15)
Pull out the worn carbon brushes by pushing
aside the spring clips, insert the new ones and
secure the cover. (see Fig16)
14.CHISEL AND DRILL BITS
Inspect regularly chisel and drill bits for damage
and sharpness. If in doubt obtain new chisels and
bits from a qualified dealer.

MAINTENANCE

1 There are no user serviceable parts in your
power tool except for brushes.
2 Never use water or chemical cleaners to clean
your power tool. Wipe clean with a dry cloth.
3 Always store your power tool in a dry place.
4 Keep the motor ventilation slots clean.
5 If you see some sparks flashing in the ventilation
slots, this is normal and will not damage your
power tool.

HANDY HINTS

Always use sharp good quality drill bits and
chisels.The performance of the drill is dependant
on the quality of the bits used.
- Reduce the pressure on the drill bit when it is
about to break through. This will prevent the drill
from jamming.
- When drilling a large hole, first drill a pilot hole
using a smaller drill bit.
- Always apply pressure to your drill bit in a
straight line, and if possible at right angles to the
workpiece.
- When drilling holes into walls, floors etc., always
make sure that there are no live electrical wires,
or pipe work in the path of the bit.
- Always operate your drill using both the handle
and the front handle.
- Never change the operating mode whilst the
drill is running.
- When using the product in the hammer only
mode, or when chiselling masonry, make sure
that you wear safety glasses and protective
gloves.
- Do not apply excessive pressure to the tool
when chiselling. Expressive force
does not speed up the work.