Hard Disk Installation; Built-In Hard Disk - Santec SDVR-1/TX-S User Manual

6.2 Hard Disk Installation

Usually the unit comes with one hard-disk
drive installed in compartment HD 1, which is
default-configured as a master. Serial ATA
(SATA) interface disk drives are designed for
easy installation. It is not necessary to set any
jumpers, terminators, or other settings on this
drive for proper operation. To install two
hard-disk drives in the compartments for HD 1
and HD 2, please take the following steps.
(For removable model only.)

6.2.1 Built-in hard disk

1.
Unscrew all the 4 mounting screws on the mobile
rack of the unit and detach it.
2.
Carefully lift the mobile
rack to a vertical
position.
4.
Carefully insert a SATA
hard disk.
3.
Unscrew the secured
screws to detach the
hard disk rack.
5.
Place the hard disk in
the rack.
6.
Secure the driver in the rack using 4 mounting
screws in the side-mounting holes. Please don't
tighten the screws too much, otherwise that may
damage the driver.
7.
Screw the rack into the
device, tightening in all
the 4 screws.
9.
Place the mobile rack back onto the device and
screw in all the 4 screws.
62
8.
Attach the interface
connector and the power
connector to the drive.