U017Xx Error Code Table: V.34 Transmission - Kyocera FS-1030MPF Service Manual

Error code
A DCN signal was received after transmission of a CTR signal (ECM).
U01152
A DCN signal was received after transmission of an ERR signal (ECM).
U01153
A DCN signal was received after transmission of an RNR signal (ECM).
U01154
A DCN signal was received after transmission of an SPA signal (short protocol).
U01155
During message reception, transmission time exceeded the maximum transmission time
U01160
per line.
Number of error lines exceeded limits during message reception.
U01161
A break in loop current was detected during message reception.
U01162
Polarity reversal was detected during message reception.
U01163
One page length exceeded the specified length during message reception.
U01164
A decoding error occurred during MMR message reception.
U01170
During reverse polling in V.34 mode at the transmitting unit, a JM signal was not
U01172
detected after transmission of a CM signal when receiving after transmission.
Communication was interrupted because an error occurred during an image data recep-
U01191
tion sequence in the V.34 mode.
A DIS signal with different FIF was received after transmission of a DIS signal.
U01199

(2-7) U017XX error code table: V.34 transmission

Error code
A communication error occurred in phase 2 (line probing).
U01700
A communication error occurred in phase 4 (modem parameter exchange).
U01720
Operation was interrupted due to the absence of a common communication speed
U01721
between units.
U01700: A communication error that occurs at the transmitting unit in the period after transmission of INFO0
before entering phase 3 (primary channel equivalent device training). For example, INFO0/A/Abar (B/Bbar, for
polling transmission)/INFOh was not detected.
U01720: A communication error that occurs at the transmitting unit in the period after initiating the control
channel before entering the T.30 process. For example, PPh/ALT/MPh/E was not detected.
U01721: In the absence of a common communication speed between units (including when an impossible
combination of communication speed and symbol speed occurs) after MPh exchange; 1) a DCN signal was
received from the destination unit, and the line was cut; or 2) a DIS (NSF, CSI) signal was received from the
destination unit and, in response to the signal, the unit transmitted a DCN signal, and the line was cut.
Description
Description
1-4-42
2MH/2MJ/2MK/2ML