i3 International Ax40W2 series User Manual page 34

Restart/Reset:
•
Click Restart Camera to restart your Annexxus-series camera. This will
cause a temporary disconnect, no video will be recorded while the camera is
restarting but all custom settings will be saved. Camera restart is required after
the firmware update. After clicking, a pop up will appear asking you to confirm.
Click Yes.
•
Click Factory Reset to return all settings, except for the Networking (IP)
settings to factory defaults. After clicking, a pop up will appear asking you to
confirm. Click Yes.
•
Click Hard Factory Reset to return all camera settings, including IP address,
to factory defaults. After clicking, a pop up will appear asking you to confirm.
Click Yes.
Note: Your Network Camera's default IP address is 192.0.0.16 and the
default subnet mask address is 255.255.255.0.
Export Configuration:
•
Click Export File to export your camera's settings. If you have multiple
cameras of the same model and you would like to apply a set of customer
settings to each one, exporting the configuration file may save time.
•
Click Browse to locate a configuration file to apply new settings to your
camera and click Import File.
After making any setting adjustments, remember to click the Save button
to save any changes made.
i3-TRNG-CAMS-Ax40W.indd
34
Rev. 141126