i3 International Ax40W2 series User Manual page 10

3.6 Adjusting the Camera Position
1. Loosen two screws, as shown in the picture below.
2. Adjust the lens to the desired shooting angle until the required view is achieved
3. Re-tighten the screws once the desired view is achieved.
Loosen two screws
before adjusting the lens
3.7 Completing the Installation
1. Re-attach the dome cover carefully
2. Re-tighten two screws that hold the camera dome cover. This completes the
installation.
10
i3-TRNG-CAMS-Ax40W.indd Rev. 141126